Cybernetics And Systems Analysis logo
Editorial Board Announcements Abstracts Authors Archive
KIBERNETYKA TA SYSTEMNYI ANALIZ
International Theoretical Science Journal
-->

DOI 10.34229/KCA2522-9664.24.6.5
UDC 517.977.5
V.A. Krasnoshapka1, V.V. Krasnoshapka2,
J.V. Pisarenko3, K.Y. Mamedova4



1 V.M. Glushkov Institute of Cybernetics, National Academy of Sciences of Ukraine, Kyiv, Ukraine

kras-korf@ukr.net

2 National Technical University
“Igor Sikorsky Kyiv Polytechnic Institute,”
Kyiv, Ukraine

kras-korf@ukr.net

3 V.M. Glushkov Institute of Cybernetics, National Academy of Sciences of Ukraine, Kyiv, Ukraine

newjulia1979@gmail.com

4 National Technical University
“Igor Sikorsky Kyiv Polytechnic Institute,”
Kyiv, Ukraine

e.mamedova.2023@gmail.com

FEATURES OF THE EXCITATION OF DYNAMIC PROCESSES
IN GROUP ELECTRIC DRIVES OF PRESSURE STATES

Abstract. In the paper, a study of the influence of variable technological loads on the main line of the rolling mill is carried out. A mathematical model of the study of dynamic processes in group electric drives of crimping technological machine units (rolling mills) is presented. It is shown that the dependence of the moment of technological resistance on the speeds of the working rolls is determined by the dependence that takes into account the peculiarities of the technological load. The study of the influence of variable technological loads on the main line of the rolling mill showed that the drop in the coefficient of friction on the upper shaft is the most dangerous. It was found out that in these cases, there can be a significant mismatch of the speeds of the working rolls, and the drop in the moment of technological resistance on the upper roll is not compensated by the increase in the moment of technological resistance on the lower roll; therefore, self-oscillations are excited in the elastic links of the main line of the rolling mill, as well as unstable modes of oscillations.

Keywords: dynamic model, group machine unit, crimping mill, rolling mill.


full text

REFERENCES

  • 1. Krasnoshapka V.A. Features of dynamic processes in controlled machine units under variable technological loads. International scientific and technical journal "Problemy upravleniya i informatiki." 2016. N 2. P. 108–115

  • 2. Ivanchenko F.K., Krasnoshapka V.A. Dynamics of metallurgical machines [in Russian]. Moscow: Metallurgy, 1983. 294 p.

  • 3. Krasnoshapka V.A. On one method of separation of motions in the study of dynamic processes in multi-mass systems. Dynamics of elastic systems with continuously discrete parameters [in Russian]. Kyiv: Nauk. Dumka, 1976. P. 39–59

  • 4. Babakov I.M. Inverse method applied to calculation of natural frequencies of torsional vibrations. Scientific notes of KhMMI. 1935. Vol. 2, book 1. P. 18–30

  • 5. Babakov I.M. Theory of oscillations [in Russian]. Moscow: Gostekhizdat, 1958. 627 p.

  • 6. Kamke E. Handbook of ordinary differential equations [in Russian]. Moscow: Nauka, 1965. 703 p.




© 2024 Kibernetika.org. All rights reserved.